whiskersupport.com
21
Red Light: Cat Sensor Activated and Wait Time Countdown
The Cat Sensor has been activated by a cat entering the Globe. Once the cat exits, the
Wait Time countdown to a Clean cycle will begin (see page 26). You can cancel the
timer (red light) by pressing Reset.
Red Light Flashing: Cat Sensor Fault
The Cat Sensor has been continuously activated for 30 minutes or more, either by a cat
that won’t leave the Globe or by too much weight in the unit.
Check for excess weight, such as too much litter or waste. When you are done, press
the Reset button or turn the unit off then back on to reset the Cat Sensor.
Yellow Red Lights Flashing Sequentially:
Motor detects obstruction or jam during clockwise rotation. Turn the unit off and re-
move the Bonnet and Globe. Check for gear/motor obstruction. Reassemble the unit
and verify the proper litter level. Power the unit on and let it cycle. If the problem per-
sists, contact Customer Service.
Blue Yellow Red Flashing Sequentially:
Cannot find Dump position. The unit will continue to function in
Automatic Mode. Contact Customer Service.
Red Yellow Blue Flashing Sequentially:
Cannot find Home position. The unit will continue to function in
Automatic Mode. Contact Customer Service.
Blue-Yellow-Red Flashing Simultaneously:
Cannot find Home or Dump positions. The unit will not cycle.
Contact Customer Service.
Blue Red Flashing Sequentially:
Motor detects obstruction or jam during counter-clockwise rotation. Turn the unit off
and remove the Bonnet and Globe. Check for gear/motor obstruction. Reassemble the
unit and verify the proper litter level. Power the unit on and let it cycle. If the problem
persists, contact Customer Service.
To Next Page
Loading...
Need help?
General
