pg 50
VCO – Produces a varied pitch based on target depth and/or position in relationship to the
search coil.
Stereo Mixed – All metal Audio in one ear, Discrimination audio in the other.
Threshold – Background hum or Threshold for Stereo Mixed Mode.
Tone ID – Selects on/off Tone ID feature for Discrimination portion of Stereo Mixed Mode.
Specifi c Tone ID method previously selected under AUDIO, TONE, VDI TONE
Modulation - Selects the depth of the metal targets infl uence over the audio beep volume.
Range – Higher numbers = more Modulation / deeper targets produce quieter
responses.
VCO - Produces a varied pitch based on target depth and/or position in relationship to the search
coil, for the All Metal portion of the Stereo Mixed Mode.
Balance – Decide which ear you want All Metal, and which you want Discrimination.
All Metal / Disc – All Metal in left ear, Discrimination in right ear.
Disc / All Metal – Discrimination audio in left ear, All Metal audio in right ear.
Audio Boost – Boost the audio levels of Stereo Mixed mode; compensates for splitting the audio
into two channels, left and right ear.
Pinpoint Audio – Select audio options specifi
c to the Pinpoint (trigger on grip squeezed and held) mode.
VCO - Produces a varied pitch based on target depth and/or target position in relationship to the
search coil.
Ratchet - Automatically reduces the size of the target signal (to a limit) for Semi-automated
pinpointing.
Wireless Headphone – Select options specifi c for use of the wireless headphones.
Enable –Activate wireless headphone transmission.
Channel - 4 – 79 – Select a channel free of external electrical interference, must reconnect
after ever channel change.
Power Level - 1 – 3 3 = Most powerful. Select a level strong enough to receive good
quality sound.
Single (Monitor Battery) – Activate the ability to monitor the condition of the wireless
headphone battery.
Version – Manually check wireless headphone battery condition and Wireless Headphone
software version.
Speaker – Automatically switch to built in speaker if communications with wireless
headphone become poor.
Multiple Headphone – Connect multiple wireless headphones to listen to one metal detector. Does
not report battery conditions.
Connect / Exit – Menu Tab to connect, press ENTER, wait for display prompt, to activate
and connect under a new Wireless channel, or simple exit without change.
FREQUENCY – Make selections that dictate operating frequency (metal detection
transmitting and receiving).
Three Frequency – Choose to transmit and receive all three available primary
frequencies.
VDI –Select different methods of processing target information reported
on the display when three frequencies are used.
Best Data – Compare all three frequencies and then use the
target information from the frequency that appears to be the most
reliable.
Complete Guide to Spectra V3
i
®
To Next Page
Loading...
