Need help?Do you have a question about the Wide M series and is the answer not in the manual?
General| Panel Type | IPS |
|---|---|
| Aspect Ratio | 16:9 |
| Response Time | 5ms |
| Refresh Rate | 60Hz |
| Screen Size | 27 inches |
| Resolution | 1920x1080 (Full HD) |
| Brightness | 250 cd/m² |
| Contrast Ratio | 1000:1 |
| Color Gamut | 72% NTSC |
| VESA Mount | 100x100mm |
| Weight | 4.5kg |
| Viewing Angle | 178°/178° |
| Ports | HDMI, VGA, Audio Out |
Install video adaptor and its drivers, referring to hardware manufacturers' guides.
Connect cables in Landscape mode; use DVI-1 for Display 1 and DVI-2 for Display 2.
Insert CD, run 'lumicalinstall.exe' for RealVision or Matrox graphics adaptors.
Access Display Properties via Control Panel and extend Windows desktop to monitor 2.
Connect USB cables; install monitor driver manually, not automatically.
Run 'LumicalInstall.exe', uncheck 'This display is not controlled', select 'It does not divide'.
Set unique identifiers (e.g., 20, 30) and enter serial number for each display.
Enter license key upon first run; trial period is 30 days.
Open calibration window via quick start icon, then select monitors for calibration.
Configure maximum luminance, use min/max for calibration, and set measuring points for accuracy.
Remove old drivers, use higher priority PCI slot, and install color display first.
Check LED, cables, and resolution for display signal problems in single/dual configurations.
Address image centering, split screen, or resolution change problems by checking drivers and adaptor support.
Troubleshoot stuck sensors by restarting; check library file for moving sensor problems.
Ensure correct video drivers and communication library are selected for calibration startup.
Contact WIDE for the latest S/W if WIDEUSBIF.DLL is not found in the library selection.
To Next Page
