EN
WIKA operating instructions pressure gauge, model 2, copper alloy 7
14306500.01 09/2019 EN/DE
Any change in the state of the matter or any decomposition of unstable
media is not permitted.
Only use the instrument in applications that lie within its technical
performance limits (e.g. max. ambient temperature, material compati-
bility, ...).
In order to achieve an optimal service life of the instrument,
it is recommended to load the instrument between 1/3 x PS
and 2/3 x PS. See Technical information IN 00.05.
This instrument is not permitted to be used in hazardous areas!
The instrument has been designed and built solely for the intended use
described here, and may only be used accordingly.
and the limit values in accordance with EN 837-1 must be observed.
Improper handling or operation of the instrument outside of its technical
the instrument to be taken out of service immediately and inspected by
an authorised WIKA service engineer.
With instruments which do not correspond to a safety version per
EN 837 highly pressurised media might leak out through the possibly
bursting window in case of a component failure.
The manufacturer shall not be liable for claims of any type based on
operation contrary to the intended use.
3. Safety
To Next Page
Loading...
Need help?
General
