WIKA CPG1200 - Page 41

41WIKA operating instructions, model CPG1200
EN
14603921.02 06/2023 EN/DE
■
Arithmetic mean value if measuring interval < logger interval
■
Peak Min./Max. if interval > measuring rate
■
Temperature value
■
Set zero value
■
Density
The stored logger processes can be downloaded via USB or Bluetooth
®
interface using
the following software:
■
WIKA-Cal Log
■
WIKA-DCS
■
myWIKA Device App
To download using the app, a Bluetooth
®
connection is required
The following functions are blocked during the logger process:
■
Change unit
■
Change Tare or activate/deactivate
■
Change measuring rate
■
Delete last logger process
■
Delete all logger data sets
■
Reset to factory settings
7.3.2 Interval
The Interval function defines the time between two pressure value recordings.
If the logger interval is set to 0, the measuring rate is used. If, in this case, the measuring
rate is set to logger interval, the measuring rate is automatically set to 1/s.
In order to change the logger interval, proceed as follows under “Menu” / “Logger” /
“Interval”:
1. Enter the desired logger interval in seconds in the input field. (The input is made
from left to right.)
2. Use the [LIGHT/▼] button or [ZERO/▲] button to select the number and use the
[MENU/◀▶] button to jump one digit to the right.
The input can be aborted with the [Home] button. The instrument exits the
menu, the input is not adopted.
To accept the set logger interval value, press the [MENU/◀▶] button repeatedly until
the instrument jumps back one menu level.
Press the [HOME] button in order to exit the menu.
7. Operation via menu functions