WIKA CPG1200 - Page 42

42 WIKA operating instructions, model CPG1200
EN
14603921.02 06/2023 EN/DE
7.3.3 Duration
The Duration function specifies the time from the start to the automatic stop of the
logger process. If the duration is set to “OFF”, the logger process will continue until one
of the following occurs:
■
Manual stop of the logger process
■
Batteries discharged
■
Logger memory full
This function is only displayed in combination with the accuracy 0.25 % FS.
In order to change the Logger duration, proceed as follows under “Menu” / “Logger” /
“Duration”:
1. With the [LIGHT/▼] button or [ZERO/▲] button, select the desired action.
2. Confirm the selection with the [MENU/◀▶] button.
⇒
With ON or OFF, the instrument moves back one menu level.
⇒
If Duration is selected, an input field appears with hour, minute and second
values. (The input is made from left to right.)
3. Use the [LIGHT/▼] button or [ZERO/▲] button to select the number and use the
[MENU/◀▶] button to jump one digit to the right.
The input can be aborted with the [Home] button. The instrument exits the
menu.
Press the [HOME] button in order to exit the menu.
7.3.4 Delay
The start of the logger process can be postponed in steps of one minute up to 24 hours.
This function is only displayed in combination with the accuracy 0.25 % FS.
In order to change the delay time, proceed as follows under “Menu” / “Logger” /
“Delay”:
1. With the [LIGHT/▼] button or [ZERO/▲] button, select the desired action.
2. Confirm the selection with the [MENU/◀▶] button.
⇒
With ON or OFF, the instrument moves back one menu level.
⇒
If Delay is selected, an input field appears with hour and minute values. (The
input is made from left to right.)
3. Use the [LIGHT/▼] button or [ZERO/▲] button to select the number and use the
[MENU/◀▶] button to jump one digit to the right.
7. Operation via menu functions