58 WIKA operating instructions, model CPG1200
EN
14603921.02 06/2023 EN/DE
10.1 Dismounting
WARNING!
Physical injury
When dismounting, there is a danger from aggressive media and high
pressures.
▶
Disconnect test and calibration installations once the system has been
depressurised!
1. Switch off the digital pressure gauge CPG1200.
2. Loosen the digital pressure gauge with a spanner or torque wrench, using the
spanner flats.
3. Screw out the digital pressure gauge by hand.
4. Clean the digital pressure gauge as required, see chapter 9.3 “Cleaning”.
10.2 Return
Strictly observe the following when shipping the instrument:
All instruments delivered to WIKA must be free from any kind of hazardous substances
(acids, bases, solutions, etc.) and must therefore be cleaned before being returned.
WARNING!
Physical injuries and damage to property and the environment
through residual media
Residual media at the dismounted instrument can result in a risk to persons,
the environment and equipment.
▶
With hazardous substances, enclose the material safety data sheet for
the corresponding medium.
▶
For cleaning the instrument, see chapter 9.3 “Cleaning”.
When returning the instrument, use the original packaging or a suitable transport
packaging.
To avoid damage:
1. Place the instrument, along with the shock-absorbent material, in the packaging.
Place shock-absorbent material evenly on all sides of the transport packaging.
2. If possible, place a bag, containing a desiccant, inside the packaging.
3. Label the shipment as carriage of a highly sensitive measuring instrument.
Information on returns can be found under the heading “Service” on our
local website.
10. Dismounting, return and disposal
To Next Page
Loading...
