Page 11 of 24 pages
the stove and at least 80 cm above the ridge. If the chimney is placed at side walls, the top of
the chimney should always be higher than the ridge or the tallest point of the roof. Always be
aware of any national and/or local regulations applying to thatched roofs and the location of
the chimneys.r.
-
18-20 Pa.
The chimney must have a minimum clearing of Ø 150 mm. The chimney must be provided with
The required distance to combustible material must be complied with in accordance with the
brand label. Ask your WIKING retailer for further information.
Changing the Smoke Outlet from Top Outlet to Back Outlet (WIKING Miro 1 - Miro 4)
Proceed as follows to change the smoke outlet from top outlet to rear outlet:
5. Install the cover plate on top of the stove with the three screws.
6. Place the smoke ring in the smoke outlet hole in the back of the stove and secure it with the
three screws.
7. Replace the top plate on the stove.
A top cover can be bought as an accessory to cover the hole in the top plate of the stove if the
stove is connected to a rear smoke outlet.
Changing the Smoke Outlet from Top Outlet to Rear Outlet (WIKING Miro 5 - Miro 6)
(drawing F)
Proceed as follows to change the smoke outlet from top outlet to rear outlet:
and forward.
compartment. Remove the smoke ring.
-
the three screws.
To Next Page
Loading...
