Page 12 of 24 pages
A top cover can be bought as an accessory to cover the hole in the top plate of the stove if the
stove is connected to a rear smoke outlet.
Connection to chimney
All the stoves have both back and top smoke outlet that can be connected to an approved steel
chimney on top or directly out at the rear to a chimney.
Make sure that the chimney is tight and that no false draft is caused around neither the cover
plate, in connection with a covered smoke outlet, nor the cleanout door and pipe connections.
3. Vermiculite rear plate.
4. Vermiculite corner plate.
5. Vermiculite side plate.
6. Bottom plate
7. Protection during transportation
8. Fittings
Please note: The combustion chamber is covered with plates made of vermiculite, which is a
heat-insulating material. These plates ensure that the optimal combustion temperature is quickly
reached, and they must therefore remain inside in the wood-burning stove.
their warmth within the stove and the surrounding area. In this way you get more warmth from
the wood you add to the stove, as the warm smoke is not simply sent out through the chimney.
Fitting the loose parts
that all insulation plates of the combustion chamber have been properly placed, i.e. that the
bottom plate is horizontal and that the side plates are vertical and reach all the way up to the
steel sides of the combustion chamber and down to the bottom plate.
1.
as protection during transportation. Remember to remove the two pins before you start
using the stove.
2.
of the combustion chamber and must be pushed as far back as possible into the combu-
stion chamber.
3.
4.
To Next Page
Loading...
