Wilfa COOL 9 CONNECTED - Remote Control Usage

18
EN
INSTRUCTION MANUAL · AIR CONDITIONER
3 +/- button
• Pressing “+” or “-” button once will increase or decrease set temperature by
1°C (°F). Hold “+” or “-” button for 2s, set temperature on remote controller
will change quickly.
• Release the button after your required set temperature is reached.
Under timer setting status, after each pressing of “+” or “-” button, time will
increase or decrease 0.5h. Hold “+” or “-” button and the time on the display
will change quickly.
4 Swing button
Not available for this unit.
5 Fan button
This button sets the fan speed. The sequence goes from auto, 1, 2, 3, and back
to auto.
6 Sleep button
Press this button to turn the sleep mode on. This function maintains the most
comfortable temperature for you.
7 Timer button
• Press this button once and the characters of HOUR ON (OFF) will ash.
• Meanwhile, press “+” button or “-” button to adjust timer setting (time will
change quickly if holding “+” or “-” button). Time range is 0.5~24hours.
• Press this button again to conrm timer setting and the characters of HOUR
ON (OFF) will stop ashing.
If the characters are ashing but you haven’t press timer button, timer setting
status will be stopped after 5s. If timer is conrmed, press this button again to
cancel timer.
8 Health button
Not available for this unit.
9 Wi- button
• Press “WiFi“ button to turn on WiFi function, “WiFi“ icon will be displayed on
the remote controller: Hold “WiFi“ button for 5s to turn off WiFi function and
“WiFi“ icon will disappear.
• Under off status, press “MODE” and “WiFi“ buttons simultaneously for 1s,
WiFi module will restore factory settings.