EasyManua.ls Logo

Wilfa COOL 9 CONNECTED - CLEANING AND MAINTENANCE; Cleaning Procedures and Warnings

Wilfa COOL 9 CONNECTED
356 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
20
EN
INSTRUCTION MANUAL · AIR CONDITIONER
CLEANING AND MAINTENANCE
Warning:
Before cleaning the air conditioner, please turn off the unit and disconnect
power. Otherwise, it may cause electric shock.
Do not wash air conditioner with water. It may cause electric shock.
Do not use volatile liquid (such as thinner or gas) to clean the air conditioner.
Otherwise, it may damage the appearance of air conditioner.
Do not splash water or any other liquid into it, it may damage the plastic
components, even cause electric shock.
CLEAN OUTER CASE
If there is dust on the surface of outer case, please use soft towel to wipe it. If the
outer case is very dirty (such as grease), please use neutral abluent to wipe it.
CLEAN GRILLE
Use cleaner or soft brush to clean it.
CLEAN FILTER
1. Remove the lter.
Press the clasp, and then remove the lter 1.
Pull out the lter 2.
2. Clean lter
Use cleaner or water to clean the lter. If the lter is very dirty (such as
grease), use warm water 40°C (104°F) mixed with neutral detergent to clean
it and then put at shady place to dry it.
3. Install the lter.
After the lter is cleaned and dried, reinstall it correctly.
Note:
The lter should be cleaned about once every three months. If there’s much
dust in the operation environment, you can increase clean frequency.
Do not dry the lter with re or hair drier. Otherwise, it may be deformed or
catch re.
CLEAN HEAT DISCHARGE PIPE
Remove the heat discharge pipe from air conditioner, clean and dry it, and
then reinstall it. (For the method of installation and removal, please refer to the
instruction for ”installation and disassembly of heat discharge pipe”).

Table of Contents

Related product manuals