Wilfa COOL 9 CONNECTED - INSTALLATION; Installation Precautions & Location; Electrical Connection & Preparation

25
EN
AIR CONDITIONER · COOL 9 CONNECTED
INSTALLATION
PRECAUTIONS
Warning:
• Observe all governing codes and ordinances.
• Do not use damaged or non-standard power cord.
• Be careful during installation and maintenance. Prohibit incorrect operation to
prevent electric shock, casualty and other accidents.
SELECTION OF INSTALLATION LOCATION – BASIC REQUIREMENTS
Installing the unit in the following places may cause malfunction. If it is
unavoidable, please consult the local dealer:
1. The place with strong heat sources, vapours, ammable, or explosive gas, or
volatile objects spread in the air.
2. The place with high-frequency devices (such as welding machine, medical
equipment).
3. The place near coast area.
4. The place with oil or fumes in the air.
5. The place with sulfureted gas.
6. Other places with special circumstances.
7. It’s not allowed to be installed on the unstable or motive base structure (such
as truck) or in the corrosive environment (such as chemical factory).
REQUIREMENT OF AIR CONDITIONER
1. Air inlet should be far away from obstacles and do not put any objects near
air outlet. Otherwise, it will affect the radiation of heat discharge pipe.
2. Please try your best to keep far away from uorescent lamp.
3. The appliance shall not be installed in the laundry. High humidity can cause
malfunction.
REQUIREMENTS FOR ELECTRIC CONNECTION
Safety precautions:
1. Must follow the electric safety regulations when installing the unit.
2. According to the local safety regulations, use qualied power supply circuit.
3. If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualied persons in order to avoid a hazard.
4. Properly connect the live wire, neutral wire and grounding wire of power
socket.
5. Be sure to cut off the power supply before proceeding any work related to
electricity and safety.