Willcox & Gibbs W562 - Replacing Oil Filter; Silicone Oil for H.R. Device; Needles; Replacing Needles

REPLACING OIL FILTER
Refer to Fig. 11 and disassemble O O in
sequence.
Clean Oil Filter O or if necessary, replace it
with a new one.
SILICONE OIL FOR H.R. DEVICE
Keep Reservoirs 0 and 0 with factory supplied
silicone oil or equivalent.
Never use this oil to lubricate any machine
parts.
NEEDLES
The standard needle is as shown in Table 3.
REPLACING NEEDLES
Loosen. Screw O and replace needles.
Insert a new needle into the needle hole as far
as it will go, making sure the long groove on
the needle is facing you.
— Note:
When loosening or tightening Screw ©,
insert the tip of the alien key fully into the
hexagonal hole of Screw 0.
NEEDLE SYSTEM AND SIZE
Table 3
NEEDLE SYSTEM
NEEDLE SIZE
2-needle
3-needle
Schmetz UY128GAS
#70
#75
Organ UY128GAS
# 1 0
# 1 1
Please note that the needle size varies depending on the
number of needles in the machine.
-6 -
From the library of: Superior Sewing Machine & Supply LLC