3. Quick Start
3.1 How to Start the Camera?
Switch ON “Power Switch”
Note: Camera comes pre-programmed with factory default settings. So for test purpose,
user only needs to insert a SD card and batteries to start test by powering on.
3.2 How to Set the Functions?
a. Switch ON “Power Switch”, Press “OK” once to enter Test mode; then press button “Menu”
once to enter camera setting menu;
Use navigation buttons“←”, “↑”, “→”, or “↓”to obtain favored settings, press
“OK”for confirmation and save the preferred change, press “Menu” to exit current page;
b. Exit main menu, then press button “OK” for 3 secs to enable camera to work on PIR.
c. Camera LED indicator flashes 5 times before it gets into PIR auto working mode.
Note: For some settings, user needs to press “Menu” to save & exit the configuration
after pressing “OK”to confirm; (Cam ID, Delay, Time Lapse, Timer, Password)
3.3 How to Enable Camera to Send Photos
1) Camera will automatically enter MMS & 3G setups when the SIM card is inserted;
2) If "SIM Automatch failed, pls enter setups manually" pops up on screen, pls switch
“SIM Auto Match” to “Manual” mode, then enter MMS & 3G setups in “Manual Setup”;
3) Enter recipient phone number(s) & email account(s);
4) As if you’d prefer to allow camera to consume 3G data flow of your SIM card only, pls
remember to enter receiving email accounts, and delete MMS setups from Menu.
Note: As if you’d like to use your own SMTP server for sending photos, pls switch “Default”
to “Manual” mode for further configurations.
5) Without SMTP configured, camera will send photos to both phone number and email by
consuming MMS charge.
To Next Page
Loading...