BELT CLIP INSTALLATION FOR PPA R35 AND PPA R35-8
TO INSTALL:
Position the belt clip on the rear of the R-35 or R35-8 receiver as
shown in Figure 6A. Turn the belt clip 180º left or right as shown
in Figure 6B. The belt clip is now installed and ready for use.
TO REMOVE:
Turn the belt clip 180º so the edge points toward the top of the
unit as shown in figure 6B. Gently pull the belt clip away from
the unit to remove.
E
ARPAD CLEANING FOR PPA R35
Do not immerse the earphone in water or other cleaning agent. Foam
pads may be removed and washed with a mild laundry soap solution,
rinsed thoroughly, and air dried. You may also opt to purchase new
foam pads.
Call Customer Service for ordering information:
1-800-843-3544
To Next Page
Loading...
Need help?
General
