Installations in the State of Massachusetts
22
b. Be either hardwired or battery powered or both; and
c. Shall comply with NFPA 720 (2005 Edition).
3. A product approved vent terminal must be used, and if applicable, a product approved air intake must be used. Installation shall be
in strict compliance with the manufacturer's instructions. A copy of the installation instructions shall remain with the appliance or
equipment at the completion of the installation.
4. A metal or plastic identification plate shall be mounted at the exterior of the building, four feet directly above the location of vent
terminal. The plate shall be of sufficient size to be easily read from a distance of eight feet away, and read "Gas Vent Directly
Below".
Replacement Parts List
Reference
Number
Item
Number
Description Qty.
1 6H24 Inner Frame 1
2 6H03 Bottom Support Cover 1
3 6H01 Heat Exchanger Support 1
4 P323702 17.5K Heat Exchanger Asy 1
5 6H13 Blower Housing Support, Right 1
6 6H12 Blower Housing Deflector 1
7 6H04 Blowet Housing Assembly 1
8 6H49 Outer Panel 1
9 6H14 Air Baffle 1
10 6H02 Front Heat Shield 1
11 P323458 Inducer Fan 1
12 6H26 Condensate Trap Support 1
13 P323457 Condensate Trap 1
14 P323452 Gas Valve 1
15 P323483 Valve Bracket Screw 2
16 P323455 Main Coils Connector 1
17 P323456 Modular Solenoid Connector 1
18 P323468 Air Pressure Sensor 1
19 P323467 Wire Harness 1
20 6H29 Switch Bracket 1
21 P323469 On/Off Switch 2
22 P309600 Hi Limit Switch 1
23 P323450 Control Board 1
24 P323451 Display Panel 1
25 P323461 Touch Screen 1
26 6H30 Air Filter Guide 2
27 P323470 Air Filter 1
28 P323466 Thermistor Assembly 1
29 6H19 Air Pan 1
30 P323482 Inducer Fan Mounting Washer 4
31 6H16 Inlet Pipe Stop 1
32 6H18 Rear Panel 1
33 6H38 Exhaust Grill Assembly 1
To Next Page
Loading...
