Williams OVERTURE III - Assembly Instructions (Continued); Stand Assembly - Step 5 & 6

OVERTURE III DIGITAL PIANO
WILLIAMSPIANOS.COM
5
STEP 5
Screwthemodestlypanelintothe
bracketsandlegsusingthepre-
drilledholesandincludedscrews
withwashersE (M4X10).
Thevanityboardshouldbeon
thefrontsideofthebrackets,
andscrewsshouldenterthrough
thefrontsideofthepiano.
STEP 6
Placethemainpianosectionon
topofthelegs.
Slipthetwotabsonthebottom
ofthepianointotheU-shaped
bracketstowardtherearof
thestand.UsefourF (M6x20)
screwstosecurethebrackets.
Tightenallfourscrews.
20453755 Williams Overture III Owner's Manual_V3.indd 520453755 Williams Overture III Owner's Manual_V3.indd 5 8/2/21 1:57 PM8/2/21 1:57 PM