WILLVS MODEL "MB" NTON
4
x
4
GOVERNMENT
TRUCK
02-5
DRIVER'S INSTRUCTIONS
This vehicle should nol be dewen jasler than
40
miles an hour for the firsl
100
miles nor more
lhan
50
miles an hour from
l00
to
500
mihs.
Ij lhe wehicle is opernted at ewcessive speeds while
nm,
lhe closely fillcd parts may possibly become overheatcd, resulfing in serious damage
ia
mcchnnical
units. Never race the Enginc while making adjusiments or u~hen vehicle is standint idle.
é
7
8
91011
i2i3i4i6i'si7ieioeoz'iizisi426is
FIG.
l-CONTROLS
It is very important that tlie driver of this vehicle
to second position. This
closes eritire briglit light
be
thoroi~ghly familiar with tlie various Controls
circuit, which consists of two
Iiend lanil~s-instru-
and their nroper use. The most exnerienced driver
ment
Danel lam~s. sto~ and tail Iamos.
should study the Controls becaise there are a
number wliich are not ordinarily found on standarcl
vehicles.
Illustrations show the controls, instruments and
instruction plates; in tlie following paragraphs we
reler to these illiistrations by the key numbers so
tlie reader may easily
follow tlie instructions.
Ignition Switch-No.
9,
Fig.
1
Is operated by a key, turning key to right (clock-
wise) closes tlie ignition circuit. Turning key to
Ieft (counter clockwise) opens the ignition circuit
and shuts
off tlie engine.
Light Switch-No.
6,
Fig.
1
The liglit switch
is
the push-pull type with safety
lock.
This switch coiitrols tlie entire lighting system
including the instrument panel
liglits and stop
lights.
When the control knob is pulled out to the first
position, the blackout lamp circuit is closed-wliich
consists of two blackout lamps, stop and tail lamps.
To obtain bright lights, push in lockout control
button on left of switch and pull out control knob
..
.
CAUTION: When driving during the day press
in lockout control biitton and pull Coiitrol Knob
out to the last or Stop
Light position to ratise
regular Stop Light to operate.
Panel
Light Switch-No.
12,
Fig.
1.
The Panel Light switch controls tlie Pniiel 1,iglits
when the mairi Light Switcli is
iii
Service (1,riglit
light) position. otlierwise tlie Panel Liglits
do
iiot
operate.
HeadLamp Beam Control Switch-No.
8,
Fig.
1
Pressing and releasing tlie biitton of tlie selector
foot switch with tlie left foot alterriately cli;iiiges
the headliglit beam from high to low.
Starter Switch-No.
23,
Fig.
1
Toe board mounted to the riglit of tlie arceler-
ator; pushing button down closes starter circuit
and causes starter to crank erigine-release tlie
button as soon as the engine starts.
Hand Throttle-No.
10,
Fig.
1
Pulling control button out opens cnrbiiretor
throttle valve and increases engine speed.
To Next Page
Loading...
