02-8
w11.1.ï~
MODEL
-\rnW
!<-TON
-
Press on :iccelerator and release clutch pdal
slowly. Repent these operatioris until traris-
iiiission
is
iri
Iiigli gear.
S1111~TINC CEARS IN TRANSFER CASE
Instructioiis lor sliifting gears in transfer case
and
eiigageiiient of tlie front axle drive are as
follows: No. 21, Fig.
l
:incl Fig.
4.
1.
Traiisfer case niay be nperated in either
IiigIi or low sl>eeil raiige wlieii front axle drive
is liNGAG131).
2. Tlie transfer case can t>e operaled oiily in
"Iligli" (direct drive) wlicri froiit ax'e drive
is DISENGAGED.
3.
To engage frorit axle drive. depress cluicli
pedal, release accelerator and more center sliift
lever to
rear ~>ositioii. No. 21. Fig. 1.
4.
To
disengage front axle drive. release accelera-
tor
ancl sliift lever tv forward position.
5.
Sliiftiiig frniii Iiigli to low gear slioiild not be
atieiiiptcil escept \\.lien tlie veliicle is being
nl>eratwl at
IOIV
speeds or at n standstill. Tlie
froiit axle
<Irivc iiiiist be engagecl [«r tliis sliift.
Iklease acceleratirr aiid depress clutch pcdal-
move reriicr sliift lever to rear positiori, engag-
iiig front wlieel drive, No. 21. Fig.
I.
then niove
riglit
li;iiiil
sliift Icver, Sn. 22. to forward posi-
tinii.
G.
Sliifiiiig frfiiii I<iw to IiigIi ycar niay be accíiiii-
plislie<l ;it aiiy tiiiie, reg;irclless of vehicle sl>ccd.
I<r.lc:isc :ici:clrrat.or ani1 (lel~ress cliitcli peilal-
sliift riglit Iiniid Icver iiito rear positiori.
SIIIFTING
T0
LOWER SPEED IN
TRANSRtISSION
Tlie transinissinii gears slii~uld always he sliifted
to tlie iiext lowrr speed before engiiie begins to
Ial>«r or before veliiclc sl>ecd is rediiced appreciably.
Sliifting to luwer speed
is
accoml~lislied as follnws:
1.
Depress clutcli pcclal quickly, increase engirie
specd and sliift to ricxt lower gear, rclcase
clutcli slowly aiid aceelerate.
It is advisable to iise tlie saine transmissii>ii gear
going clown a Inrig
Iiill
as wi~iilrl be reqiiireíl io
climb tlie =me hill.
STOPPING TIIE VEIIIC1.E
1.
Remove font froiii accelerator peilal and
apply
hrakes hy pressing dowii «ti brake pedal.
No. 14. Fig.
1.
-
2.
\I!heii veliicle speed Iias been re<luce<l to idling
eiigiiie speed. clisengage cliitcli ;ind iiiove tratis-
mission sliift lever. So.
IS.
Fig.
I
to neutral
p.>sitii)n. See Fig. 4.
3.
Wlicii veliicle Iias come tij
n
roniplete stop
ay>l>ly hand brake, No. 24, Fig.
l.
aiid release
clutcli
and brake pedals.
SIIIFTING
INT0 REVERSE
Hefnre zittempting to sliift into reverse the vehicle
iiiiist be I~rought to a complete stop.
1.
Push clutcli pedal down to ilismgagc clutcli.
2.
Shift transmission lever to tlie lelt aiid forward
toward
instrurnetit board. Fig.
4.
3.
Release clutch peclal slowly aiid arrel~rate as
Inad is pirke<l
UI).
TOWING VEIIICLE
When
necessary tn tow x-ehicle tlie tow chain.
rope or cal>le, slioiilcl Ije attaclied to tlie front
hi~ml~er !>ar aiid frame sicle rail giisset. Fig.
5
and
G.
I.oi>p cliaiii or rope over tnp of huinper aiid
franie giisset briiiyiiig it iip ;icri>ss face of bumper
arid b;irk
on
iq~rx)sitc siilr
(if
frame, tlicti liook «r
tic. Do iiot tow frorn tlie iiii<l<lle of tlic bilinper.
FIRE EXTINGUISIIER
The fire extiiiguislier
is
mounted on left side
cowl panel Fig.
I.
l'o rerniivc piill oiit\v;ird on
clamp release lever.
'I'o olterate extingiiislier, Iiold body
iii
olie Iiatid
ancl witli tlie otlier tiirii Iiaii<lle to lelt
!d
turii
wliicli releases pluiiger lock. IJse piiiiiping actioii
to force Huid oii fire.
Ilen<l instriictions o11 Tire extingiiisher plate.
To Next Page
Loading...
