WILMS DFL 3000 - Start and Manual Reset; Overheat Protection

START:
1. Ensure the control switch is set to the OFF position before
connecting the power supply.
2. Connect the mains plug to a suitable 230 V – 50 Hz supply.
3. Switch to requested position.
(H = High, M = Medium, L = Low)
4. An additional socket allows the operation of another electrical device.
(max. 15 A / 3,5 kW)
Overheating Protection:
This fan motor is fitted with a thermal overload protection circuit to prevent overheating.
If an overheat temperature is reached the unit will shut off automatically.
Normal operation will resume when the appliance cools down.
6 of 10