Wilo CIF-Module Modbus RTU - Intended Use

Intended use en
Installation and operating instructions Wilo-CIF-Module 17
CAUTION
Damage due to incorrect handling during transport and stor-
age!
Protect the device from moisture, frost and mechanical damage during transport
and temporary storage.
4 Intended use
ƒ The CIF modules are designed for external control and signalling of the operating
status of Wilo pumps.
ƒ The CIF modules are not designed for safe deactivation of the pump.
DANGER
Risk of fatal electrical shock!
If used improperly, there is a risk of fatal injury due to electric shock!
• Never use the control inputs for safety functions.
• Never install the module in non-compatible devices.
4.1 Compatibility of the firmware
To ensure that the functions of the CIF module are available, the following firmware
versions (or higher) of the product in which the module is installed are required:
Pump Version Comments
Wilo-Stratos MAXO
01002500 CIF Modbus RTU, BACnet MS/TP, LON, PLR
Wilo-Stratos MAXO
01032101 CIF CANopen
Wilo-Stratos MAXO
01042500 CIF Ethernet Multi-protocol (Modbus TCP, BACnet/IP)
Table1: Firmware version
NOTICE
The firmware version (SW) can be called up via the settings/device settings/device
information menu.
The firmware can be updated with the “Wilo-Assistant” app.
For compatibility with products not listed above, see
www.wilo.de/automation (German), www.wilo.com/automation (English).