Installation and operating instructions Wilo-Star-Z 15 TT 17
English
Safety
2Safety
About these instructions • Read through these instructions completely before attempt-
ing installation. Non-observance of the safety instructions
can result in risk of injury to persons and damage to pump/
unit.
• When the installation work is complete, pass on the instruc-
tions to the end user.
• Keep the instructions near the pump. They can be used as a
reference if problems occur later.
• We accept no liability for damage resulting from failure to
follow these instructions.
Safety information Important safety information is identified in the instructions as
follows:
Qualification The pump must only be installed by qualified personnel. The
power may only be connected by qualified personnel.
Regulations The current version of the following regulations must be
observed when installing the equipment:
• Accident prevention regulations
• DVGW worksheet W551 (in Germany)
• VDE 0370/Part 1
• Other local regulations (e.g. IEC, VDE, etc.)
Conversion, spares The pump must not be technically modified or converted. Only
use original spares.
Transport Unpack and check the pump and all accessories upon receipt.
Report any damage that has occurred in transit immediately.
Despatch the pump in the original packing only.
Danger: Indicates a danger to life due to electrical voltage.
Warning: Indicates possible danger to life or risk of injury.
Caution: Indicates possible risks to the pump or other
items.
Note: Highlights tips and information.
To Next Page
Loading...
