English
20 Subject to technical alterations! WILO SE 03/2016
8.2.2 Orientation of the display
It can be set whether the display is to be turned by 90° for the respective
arrangement of the control module, depending on whether it is installed in
horizontal or vertical position. The positional setting can be made in
menu point 3. The display position specified by the basic setting flashes with
“ON” (for horizontal installation position). The display can be switched over by
turning the setting knob. “ON” flashes for the vertical installation position. The
setting is confirmed by pressing the setting button.
Horizontal Vertical Setting
Position setting
in menu item 3
To Next Page
Loading...
