Installation and operating instructions Wilo-Stratos/-D/-Z 23
English
Menu point only appears if a Stratos IF module
was inserted with input 0...10 V.
Switch input 0...10 V on/off
Activate input 0...10 V: “ON” and the “module
motor symbol” appears in the display.
The setpoint cannot be selected manually using
the control button. "10V" is indicated in the basic
setting .
The setting can be altered by turning
the control button.
Deactivate input 0...10 V: “OFF” appears in the
display and the “motor symbol” disappears.
Setting stored.
If the input was switched on, the menu manager
jumps to menu point .
If no input voltage is applied at the 0-10 V contact,
"Off" appears on the display and the "motor
symbol" is not displayed.
LC display Setting
To Next Page
Loading...
