English
Installation and operating instructions Wilo-Drain TS 40 9
• The pump should be protected against moisture,
frost and physical damage during transport and
interim storage.
4 Applications
DANGER! Risk of electric shock!
The pump may not be used for draining swim-
ming-pools / garden ponds or similar places
when there are people in the water.
WARNING! Risk of personal injury!
• The materials are not designed for drinking
water supply.
The pump must not be used for pumping drink-
ing water.
• The pumps must not be used:
• to pump raw sewage containing faeces,
• in potentially explosive locations,
Local regulations must be observed.
The submersible motor pumps of the Wilo-Drain
TS 40 are suitable for removing dirty water and
clear fluids containing solids of max. 10 mm Ø
from shafts, pits and vessels.
They are used:
• for building and surface dewatering,
• in sewage and water-management,
• in environmental and domestic waste disposal,
• in industrial and process engineering.
The pumps
• are made from stainless steel (1.4301) and plastic
(hydraulic).
• are normally submerged by the flow medium,
• can be installed stationary or transportable, but
only vertically.
5 Product data
5.1 Type code
5.3 Scope of supply
Each pump is supplied with
• 5 / 10 m connecting cable,
• plug (earthing pin), (for single-phase current)
• built-in non return valve,
• connected float switch (A-version),
• hose connection 1½",
• pipe connection with outside thread 1½",
• Installation and operating instructions.
Example: TS 40/10 A 1-230-50-2-5M KA,
TS 40/14 3-400-50-2-10M KA
TS Series: submersible motor pump, waste water
40 Nominal width: 40 = Rp 1½
/10 Maximum pump lift [m]: 10, 14
A A = with float switch, connecting cable with
plug
- = not specified: without float switch, con-
necting cable with free cable end for
3
~
motor
1-230 Mains voltage: 1
~
230 V, single-phase motor,
3
~
400 V, three-phase motor
-50 Mains frequency [Hz]
-2 2 poles
-10M KA Connecting cable length [m]: 5, 10
5.2 Technical data
Permissible components of the flow Mildly acidic / mildly alkaline,
media: Chloride content max. 150 mg/l (for 1.4301 / AISI 304),
max. permissible grain size:
10 mm
Mains voltage:
1
~
230 V, ± 10 %, 3
~
400 V, ± 10 %
Mains frequency: 50 Hz
System of protection:
IP 68
Speed:
max. 2900
1
/min (50 Hz)
max. current consumption:
see rating plate
Power input P1:
see rating plate
Motor power rating P2:
see rating plate
max. flow rate:
see rating plate
max. pump lift:
see rating plate
Operating mode S1: 200 operating hours a year
Operating mode S3 (optimum):
Intermittent service, 25 % (2.5 min mode, 7.5 min break).
recommended operating frequency:
20
1
/
h
max. operating frequency:
50
1
/
h
Nominal width of pipe mount: see rating plate
Temperature range of the flow medium:
+3 to 35 °C
max. immersion depth:
5 m
Oil filling:
ELFOLNA DS 22 or comparable, 410 ml
To Next Page
Loading...
