Need help?Do you have a question about the Wilo Wilo-EMU FA + FK 202 and is the answer not in the manual?
General| Brand | Wilo |
|---|---|
| Model | Wilo-EMU FA + FK 202 |
| Category | Water Pump |
| Language | English |
Defines DANGER, WARNING, CAUTION, and NOTE signal words and lists common safety symbols used in the manual.
Specifies qualifications required for personnel performing electrical work, installation, and maintenance tasks.
Details requirements for qualified electricians, mains connection, and device earthing.
Warns against pumping explosive or hazardous fluids and lists fluids the pumps must not be used for.
Specifies that electrical work must be done by a qualified electrician and installation/dismantling by trained technicians.
Covers dangers of autonomous work, protective equipment, lifting equipment use, and preparing the installation site.
Highlights the risk of death due to electrocution and stresses the need for qualified electricians for electrical work.
Specifies that electrical work requires a qualified electrician and operating personnel must be instructed.
Details how to check the motor's direction of rotation and how to correct it if incorrect.
Lists checks to perform before activation, including installation, level control, and operating conditions.
Step-by-step instructions for changing the oil in the motor compartment for FK 17.1 and FK 202/34/42 models, with safety warnings.
Detailed instructions for changing oil in the sealing chamber for FK 17.1 and FK 202/34/42 models, including safety warnings.
Lists common causes and solutions for a pump failing to start, including power supply and motor checks.
Addresses issues where the motor protection trips shortly after startup, such as incorrect settings or voltage drops.
Covers reasons for no volume flow, including no fluid, clogged inlets, jammed hydraulics, or blocked pipe systems.
To Next Page