Can I use my own cable for my installation?
Yes! However, the commonly available low-loss RG6 cable included with your product has been specifically
selected for the SIGNALBOOST DT. RG6 is a commonly available cable, you can buy it from Wilson
Electronics, or from your local electronics/hardware store. Use of another type or longer length of cable will
likely degrade the system’s performance.
There are frequently several people using cell phones in my office at the same time – will the SIGNALBOOST
DT improve the signal for all of them?
Absolutely! The SIGNALBOOST DT is designed to support multiple users simultaneously (within the range of
the Desktop Antenna).
Can I use different antennas than the ones supplied in the box?
Yes! While the SIGNALBOOST DT is designed to give you reliable signal improvement with the included
antennas, Wilson Electronics offers a variety of optional antennas and accessories that enable you to
customize your SIGNALBOOST DT to your specific needs. Visit www.WilsonElectronics.com for details.
I have questions about my installation – where can I get some help?
Wilson Electronics Technical Support representatives are just a phone call or email away.
Call 866-294-1660 or 435-673-5021, or send an email to tech@wilsonelectronics.com.
For Weak Areas with Insufficient Signal
In areas with particularly weak outside
signals, additional coverage can be
obtained by upgrading the inside antenna
and replacing it with a high-gain inside
Panel Antenna (Wilson part #301147).
This antenna (which includes RG58 cable)
can double the inside coverage area
(See Figure 13). Additional coverage can
be obtained by upgrading to the outside
antenna option to #301157 Outdoor
Panel or #304475 Wide Band Directional
Antenna.
Signal
Booster
Cell
Tower
Cradle
Antenna
Panel
Antenna
Figure 13
Optional Panel Antenna
(with cable) for improved coverage
inside the building
(Wilson part # 301147)
Minimum 15
feet separation
To Next Page
Loading...
Need help?
General
