Need help?Do you have a question about the Wilson Electronics weBoost DRIVE X RV and is the answer not in the manual?
Describes using an existing point for cable entry.
Describes routing cable through the RV slider using its gasket.
Describes drilling a new hole for cable entry with the included saw bit.
Connects the cable from the outside antenna to the booster's port.
Connects the inside antenna cable to the booster's port.
Explains how to interpret signal strength measurements in dBm.
Addresses common questions about booster installation and operation.
General| Brand | Wilson Electronics |
|---|---|
| Model | weBoost DRIVE X RV |
| Category | Extender |
| Language | English |
To Next Page