Need help?Do you have a question about the Wilson Electronics weBoost DRIVE X and is the answer not in the manual?
General| Brand | Wilson Electronics |
|---|---|
| Model | weBoost DRIVE X |
| Category | Extender |
| Language | English |
Lists all components included in the Drive X OTR Fleet cell signal booster kit.
Choose a location on the vehicle for antenna mounting, preferably on the metal cab for best performance.
Assemble the antenna by inserting cable through the mast, using mast extensions and thread locker if needed.
Mount the assembled outside antenna using typical vehicle mounting points or the included three-way mount.
Mount the In-Vehicle Antenna on the seat side or dash, at least 18 inches from the cellular device.
Connect the power supply leads to the vehicle battery terminals after disconnecting them.
Connect the outside and inside antenna cables to their respective ports on the booster unit.
Connect the power supply cord to the booster's 'Power' port after all other connections are made.
Explains the meaning of different indicator light states on the signal booster for status indication.
Provides guidance on resolving issues like blinking or solid red indicator lights.
Outlines essential safety precautions for using the signal booster and its components.
Details technical specifications including product number, FCC ID, frequency, and power output.
Describes the warranty terms and conditions for weBoost Signal Boosters.
To Next Page