EasyManua.ls Logo

Wilson Electronics weBoost DRIVE X - Step 7: Connect Power Supply To Booster

Wilson Electronics weBoost DRIVE X
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
CELL SIGNAL BOOSTER DRIVE X OTR FLEET
______
Step 7: Connect Power
Supply To Booster
Connect the power supply cord to the end of the Drive X
labeled “Power.”
NOTE: Do NOT connect the power to the Signal Booster until you have
connected both cables from the Inside and Outside Antennas.
Power Supply

Table of Contents

Related product manuals