Need help?Do you have a question about the Wilson Electronics WeBoost Drive Reach Flex Fleet and is the answer not in the manual?
General| Product Type | Cellular Signal Booster |
|---|---|
| Max Gain | 50 dB |
| Power Supply | 12V DC |
| Weight | 1.5 lbs |
| Impedance | 50 ohms |
| Frequency Bands | 700 MHz, 800 MHz, 1900 MHz |
| Frequency | 698-716 MHz, 1710-1755 MHz, 2110-2155 MHz |
| Uplink | 1710-1755 MHz |
| Downlink | 2110-2155 MHz |
| Connectors | SMA |
| Output Power | 20 dBm |
| Compatibility | All U.S. carriers (Verizon, AT&T, T-Mobile, Sprint, etc.) |
Detailed instructions for mounting the external antenna on the vehicle roof.
Guide for positioning and attaching the internal antenna inside the vehicle.
Steps for connecting the booster to the vehicle's power system via hardwiring.
How to connect the antenna cables to the main booster unit.
Finalizing the power connection to the booster unit for operation.
Indicates the booster is functioning properly with no installation issues.
Indicates a band has shut off due to oscillation; refer to troubleshooting.
Indicates reduced power due to minor oscillation; adjust separation if needed.
Indicates a potential power supply issue; verify power source.
Addresses issues with red or blinking red indicator lights and signal boost problems.
Provides answers to common questions about setup, operation, and troubleshooting.
Details regulatory requirements for signal booster use in Canada.
Explains the process of registering the booster with mobile carriers.
To Next Page