12
FIXING BLINKING OR RED LIGHT ISSUES
This section is only applicable if the Booster is red or blinking red and you are not
experiencing the desired signal boost.
■ Unplug the booster’s power supply.
■ Relocate the inside and outside antenna further from each other. The objective is
to increase the separation distance between them, so that they will not create this
feedback condition discussed before.
■ Plug power supply back in and ensure switch is in ON position.
■ Monitor the indicator light on your booster. If, after a few seconds of ‘power on’,
a solid or blinking red light appears, repeat prior steps. Increase the separation
distance until the condition is corrected and/or desired coverage area is achieved.
Note: Horizontal separation of the two antennas typically requires a shorter
separation distance than vertical separation.
If you are having any diculties while testing or installing your Booster, contact our
weBoost Customer Support team for assistance (866.294.1660).
Troubleshooting
To Next Page
Loading...
