1. To set your filter up, the buckles (1) and (2)
should be unclipped from the main body of the
filter head; this will then separate the filter head
from the filter base.
2. You can then access your filter trays to
clean the filter media or add filter media. Re-
peat step one to refasten the filter head to the
filter base.
* UV unit depends on model.
3. Push the inlet and outlet taps into the filter
head and fasten using the small handle in
between the taps; this is also the valve shut.
After this, attach a hose to each tap and se-
cure using the screw taps.
© by WilTec Wildanger Technik GmbH Item 50192–50197, 50358, 50359 Page 4
http://www.WilTec.de
http://www.aoyue.eu 11 2020-1
http://www.teichtip.de
To Next Page
Loading...
Need help?
General
