WIN Enterprises, Inc.
used as an additional data bit.
Stop Bits
Stop bits indicate the end of a serial data packet. (A start bit indicates the
beginning). The standard setting is 1 stop bit. Communication with slow devices
may require more than 1 stop bit.
Flow Control
Flow control can prevent data loss from buffer overflow. When sending data, if
the receiving buffers are full, a 'stop' signal can be sent to stop the data flow.
Once the buffers are empty, a 'start' signal can be sent to re-start the flow.
Hardware flow control uses two wires to send start/stop signals.
VT-UTF8 Combo Key Support
Enable VT-UTF8 Combination Key Support for ANSI/VT100 terminals.
Recorder Mode
With this mode enabled only text will be sent. This is to capture Terminal data.
Resolution 100x31
Enabled or disabled extended terminal resolution.
Legacy OS Redirection Resolution
On Legacy OS, the Number of Rows and Columns supported redirection.
Putty KeyPad
Select Function Key and KeyPad on Putty.
Redirection After BIOS POST
The Settings specify if BIOS is selected than Legacy console redirection is
disabled before booting to Legacy OS. Default value is Always Enable which
means Legacy console Redirection is enabled for Legacy OS.
3.4.5 CPU Configuration
This sub menu shows the CPU-related information which is automatically
detected by BIOS.
To Next Page
Loading...