6. Lengthen or shorten the stem, so when you stand upright with the
detec t or in your hand, the search coil is level with and about .5~2
inches / 1~5cm above the ground. After that tighten the lock nut.
Caution:
• The search coil cable pl ug fits into the connector only one way.
DO NOT force the plug or you could damage i t .
• DO NOT dis assemble the stem lo ck n ut.
In case you dis assemble it, place the
washer on th e top of the stem
connected with the handle with the
small head of the wash er upwards.
Then hit ch the stem lock nut on the
washer then tighten i t to lock it in place.
ADJUSTING THE SEARCH COIL
Loosen the knobs at the searc h coil’s end, adjust the searc h coil to the
desired angle . (The search coil should be parallel with the groun d.)
Tighten the knobs just enough to keep the search coil from rotati ng or
wobbling.
INSTALLING BATTERY
You need two 9V alk aline batteries to po wer your detector.
1. If the detector is on, turn the power switch (on th e
control panel) to POWER OFF.
2. Press on the bat t ery compartment cover and slide
the cover off in the direction of the arrow.
To Next Page
