- If docking station is attached, remove computer from it and retry.
Problem: Diskette will not eject when eject button is pressed.
Action: - Label may have become detached and is obstructing diskette exit:
A. Check for condition by looking inside slot;
B. Call the Service Center listed on the “Read-Me-First” packing sheet that came with the
WinBook for further instructions.
Problem: Cannot boot from floppy disk.
Action: - Boot sequence is set to boot from C: first.
A. Type ‘CTRL’ + ‘ALT’ + ‘S’ to enter setup;
B. Set boot sequence to “A:, C:”.
- Floppy does not have the correct operating system loaded on it.
- Floppy is defective.
Audio Problems
Problem: Internal audio is not functioning, or is malfunctioning.
Action: - The audio volume is turned all the way off.
- Headphones or external speakers are plugged in, but are not turned on.
- Internal audio is not enabled; enable it on Setup Page 3.
- Internal audio IRQ is not enabled; use Setup Page 3 to set this to IRQ7 (default) or IRQ5.
- Internal audio power management is interfering (disable it).
- Audio board is not installed correctly, refer to Audio Installation Guide.
- Application software or drivers are not configured correctly:
A. Select SoundBlaster option (or ESS 488 if available);
B. Select I/O port 220h;
C. Select DMA channel as 1;
D. Select either IRQ7 or IRQ5 (depending on how you have set this up on Setup Page 3).
- If docking station is installed, remove it and retry.
- If a PCMCIA Multimedia card is installed, remove it and retry.
To Next Page
Loading...