Command: ‘Pause’
This key temporarily halts a program or command –in-progress under DOS.
Break
Command: ‘Fn’ + ‘Ctrl’ + ‘Pause’
This will cause some DOS operating programs to terminate.
Num Lock
Command: ‘NumLock’
This key activates the embedded numeric keypad.
The Break Command
You must also press the ‘Ctrl’ key to activate Break.
CURSOR CONTROL KEYS
Arrow Keys
These cursor control keys move the cursor in the direction indicated. They are also available as
Fn key combinations:
‘Fn’ + ‘8’ – up
‘Fn’ + ‘U’ – left
‘Fn’ + ‘O’ – right
‘Fn’ + ‘K’ – down
Page Keys
Home, End, PgUp (Page Up) & PgDn (Page Down)
They are also available as Fn key combinations:
‘Fn’ + ‘7’ – Home
‘Fn’ + ‘J’ – End
‘Fn’ + ‘9’ – PgUp
‘Fn’ + ‘L’ – PgDn
The Page Up and Down keys move the cursor a page, or sometimes a screen, at a time. The
Home and End keys move the cursor to either the beginning or end of the file or line you’re
working on.
To Next Page
Loading...