Command: ‘Fn’ + ‘F7’
This command will force the image to fill the entire LCD screen, and is only used in DOS
applications. The changes are saved so the system will remember the setting when rebooted. It’s
only active under DOS or in DOS applications.
Setup (Power Management screen only)
Command: ‘Fn’ + ‘F8’
This command calls up the power management Setup Utility page (page 2). When you finish
your modifications and exit, the system is restored. Note that while the system is in power
management Setup, your DOS or Windows application’s state is also saved. When you leave
Power Management Setup, you automatically resume your application. The key is active no
matter which application or operating system you are using.
Invert – Normal/Reverse Video (monochrome only)
Command: ‘Fn’ + ‘F9’
This command toggles the display between Normal and Reverse modes in text mode. In most
cases you will probably want to leave it on Normal. Command is active under DOS and
Windows.
Display – Active Display
Command: ‘Fn’ + ‘F10’
This command sets the active display. The options are the LCD or a CRT monitor. Command is
active under DOS and Windows.
ScrLk
Command: ‘Fn’ + ‘Insert’
Some applications use this function to control cursor movement.
SysRq
Command: ‘Fn’ + ‘F11’
This key may be used in conjunction with other keys for other specific functions within an
application program. Consult your software user’s manuals for information.
Print Screen
Command: ‘Fn’ + ‘F12’
Pressing this key will print a text rendition of whatever is on the screen at the time.
Pause
To Next Page
Loading...