Why does Winco DE4040F4 /4 Portable Generator control valve constantly discharge?
If the control valve constantly discharges in the Winco Portable Generator, the cause may be related to the solenoid valve or the electrical system.
Why does oil escape during discharge in my Winco Portable Generator?
If oil escapes during discharge, creating oil foam in the separator cartridge of the Winco Portable Generator, the cause could be the oil type being incorrect, oil foam forming during stops, or the oil level being too high.
Why Winco Portable Generator system does not relieve?
If the Winco Portable Generator system does not relieve, this could be due to issues with the solenoid valve or electrical system, or problems with the impulse-pressure relief valve.
What causes differential pressure in Winco Portable Generator?
Differential pressure in the Winco Portable Generator can be caused by pressure in the separator cartridge being too high, often associated with a clogged or full separator cartridge.
What to do if Winco Portable Generator engine cranks but will not start?
If the Winco Portable Generator engine cranks but does not start, possible causes include improper fuel delivery, a shut-off fuel supply, an empty fuel tank, or air in the fuel system. Other potential issues are a fuel solenoid that hasn't opened, a defective fuel pump or solenoid, a defective engine harness, or improper battery voltage to the fuel pump or fuel solenoid.
Why there is oil in compressed air of Winco Portable Generator?
If there is oil in the compressed air from the Winco Portable Generator, this could be due to a soiled oil extraction line with a nozzle in the oil sight glass, a defective fine separator cartridge, or the oil level in the oil reservoir being too high, possibly due to excessive condensation.
Why Winco DE4040F4 /4 Portable Generator system continually discharges, resulting in low feed quantity?
If the Winco Portable Generator system continually discharges and has a low feed quantity, possible causes include a defective solenoid valve, a defective relief valve, or a break in the electric supply line to the solenoid valve.
Why is there no or insufficient feed quantity from my Winco DE4040F4 /4?
If there is no or insufficient feed quantity from the Winco Portable Generator, this could be due to a soiled intake filter, an oil shortage, the intake control valve not opening, or leaks in the system.
Why ATS will not transfer to Emergency Supply (generator) of Winco Portable Generator?
If the ATS will not transfer to the Emergency Supply (generator) for the Winco Portable Generator, it could be due to no AC generator output, a defective ATS control board, or a circuit breaker that is open or defective.
Why does the safety valve blow off on my Winco Portable Generator?
If the safety valve blows off on the Winco Portable Generator, it could be due to a defective safety valve, a soiled fine separator cartridge, or the system not relieving continuous operation. It may also occur if the system does not switch off automatically (drop-out mode), or due to freeze up of pressure switch because the compressor started before engine is fully warmed up.
General| Outlets | (2) 5-20R 120V 20A GFCI, (1) L5-30R 120V 30A Twist Lock |
|---|---|
| Engine Type | 4-Stroke OHV |
| Starting System | Recoil |
| Frequency (Hz) | 60 |
| Fuel Tank Capacity (Gallons) | 4 |
| Noise Level (dB) | 68 |
| Fuel Tank Capacity | 4 Gallons |
| Voltage (V) | 120 |
To Next Page
