Why Winco DE4040F4 /4 Portable Generator engine will not come up to speed after it starts?
If the Winco Portable Generator engine will not come up to speed after it starts, this could be due to insufficient fuel volume getting to the unit. Other possible causes include too small of a fuel line, fuel racks not opening properly, a defective governor, or an AC short in generator components.
What to do if Winco DE4040F4 /4 Portable Generator unit will not crank when power fails?
If the Winco Portable Generator unit will not crank when power fails, potential causes include the digital genset not being in AUTO, the transfer control switch not being in the AUTOMATIC position, or incorrect wiring between the ATS and genset. Other possible reasons are a defective control relay in the ATS, blown fuse(s) in the DSE 7310, a defective DSE 7310, loose or dirty battery terminals, a defective starter or start solenoid, or a low/dead battery.
Why is my Winco Portable Generator system difficult to start?
If the Winco Portable Generator system is difficult to start, it could be due to the compressor being flooded with oil, the system not being discharged, or the oil being too viscous. In all these cases verify engine speed is correct.
Why does my Winco Portable Generator engine start, then stop and alarm light comes on?
If the Winco Portable Generator engine starts, then stops and the alarm light comes on, the issue could stem from low engine oil pressure, high engine water temperature, or engine overspeed. It could also be due to the engine entering overcrank, no output from the AC generator, loss of speed signal, or loss of run signal.
What to do if Winco Portable Generator engine won’t crank?
If the Winco Portable Generator engine won’t crank, this may be due to a low or dead battery, blown DC fuses, or a defective DSE 7310. Other potential causes include a defective key switch, loose or dirty battery terminals, a defective starter or start solenoid, a locked-up engine genset, a defective engine harness, or improper battery voltage to the start solenoid, fuel pump, or fuel solenoid.
Why is there no AC output from my Winco Portable Generator?
If there is no AC output from the Winco Portable Generator, this could be due to a defective diode, voltage regulator, rotor, or stator. Other possible causes include a defective exciter rotor or stator, an AC short in the output leads, a defective/open generator output breaker, or a wiring error.
Why does my Winco DE4040F4 /4 have high temp shutdowns?
High temperature shutdowns in the Winco Portable Generator can be caused by several factors, including oil shortage, a soiled oil filter, a defective thermostat, or a soiled oil cooler. Incorrect installation can also lead to this issue. This includes inadequate room ventilation, blocked exhaust air, or a thermal short circuit.
General| Outlets | (2) 5-20R 120V 20A GFCI, (1) L5-30R 120V 30A Twist Lock |
|---|---|
| Engine Type | 4-Stroke OHV |
| Starting System | Recoil |
| Frequency (Hz) | 60 |
| Fuel Tank Capacity (Gallons) | 4 |
| Noise Level (dB) | 68 |
| Fuel Tank Capacity | 4 Gallons |
| Voltage (V) | 120 |
To Next Page
