Need help?Do you have a question about the Wincor Nixdorf BA63 and is the answer not in the manual?
General| Display Type | TFT LCD |
|---|---|
| Display Size | 15 inches |
| Resolution | 1024 x 768 |
| RAM | 4 GB |
| Storage | SSD |
| Operating System | Windows 7 |
| Connectivity | Ethernet, USB, Serial ports |
Wincor Nixdorf offers a 12-month limited warranty against damages occurring despite normal product use.
Instructions for disconnecting the hinge and threading the cable through the adapter and hinge.
Guide on securing the connector cable in the strain relief with a specified distance of 73 mm +/- 2 mm.
Steps for plugging the cable connector into the display and reattaching the adapter/hinge.
Instructions for pressing the release knob to disconnect the hinge from the customer display.
Procedure for threading the cable through the base and then through the hinge.
Instructions on how to connect the base and the hinge together.
The display operates in VT100 mode, emulating a subset of VT100 ESC sequences and control bytes.
Command format (02H, 00H, Data Count, Data Bytes) for issuing data, ESC sequences, or control characters.
Firmware and character sets can be updated via the USB interface using WNUpdHID.exe.
Utility requires WNHidHlp.dll; specify device type (BA63 or Nonspecific) and .DAT firmware file.
Update involves re-enumeration, progress bar, and success/error messages like 'Command reject' or 'Operation in error'.
Details common error messages ('Operation in error', 'Device not found', 'Command reject') and their causes.
Using 'Nonspecific' selection as a fallback if the BA63 is not recognized or update fails.
On-board jumpers (JP0, JP1, JP2) control self-test, font test, and manual upgrade modes.
To Next Page
