Installing The Handlebars
Installing The Headlight
7
1. Insert the headlight screw into the headlight hole as shown in the picture.
2. Use the installation tool to tighten the screws.
3. Use a hex wrench to tighten clockwise.
4. Connect the headlight wires.
6
1. Utilize a 5mm hex wrench to initially tighten the screw at position ①.
2. Loosen the screw at ② and remove the gland.
3. Securely fasten the handlebar and tighten the screws using an Allen wrench.
4. Rotate clockwise to tighten.
2
screws
hex wrench
1
To Next Page
Loading...