OPERATIONS
CMPS2 86305210 01/14/08
3-
9. Store and secure hoses and tools neatly.
10. Drain machine at proper disposal areas. Use
pressure gun to rinse and clean recovery tank.
11. From the factory your Compass 2 is set to spray
at 600 psi (high pressure) and 200 psi (low
pressure w/chemical injection). To lower
pressure turn the unloader valve knob counter
clockwise. The valve is accessed from below the
machine through a hole in the bottom frame.
Only turn the valve a maximum of three
revolutions.
Note: Lowering the pressure in this way will
reduce both of the high pressure and low
pressure setting simultaneously.
UNLOADER
VALVE
To Next Page