TECHNICAL SPECIFICATIONS
MB2000I 980071 11/15/02
3-1
ITEM DIMENSION/CAPACITY
Construction Heavy-duty die cast aluminum deck
with heavy-duty rubber bumper,
tubular steel self adjusting handle
with die cast aluminum handle
housing.
Motor 1.75 hp
Transmission Direct drive from motor shaft.
Pad speed 2000 rpm
Electrical system 230 volts, 50Hz
Cable 75’ [22.9 m], 1.5mm/3 built in cord
wrap.
Switches Dual levers with safety lock.
Pad Holder ∅20” [50.8 cm] flexible disc
Wheels
Four ∅5” [∅12.7 cm], 1.25” [3.2 cm]
wide, non-marking tread.
Handle ∅1.5” [∅3.8 cm] tubular steel, self
adjusting handle consistently
maintains full contact with the floor,
and easy to use thumb activated
safety lock.
Dimensions (L x W x H) 32” [81.3 cm] X 23.9” [60.2 cm] X
48.4” [122.9 cm]
Pad size (See note) 20” diameter x 1” thick
NOTE: Always use a pad which has been designed for electric ultra high speed burnishing of at least
2000 rpm.
The sound pressure level at the operator’s ear was measured to be 70 dBA. This was a nearfield,
broad-band measurement taken in a typical industrial environment on a tile floor. This appliance
contains no possible source of impact noise. The instantaneous sound pressure level is below 63 Pa.
To Next Page
Loading...
Need help?
General
