Service Instructions
Maintenance
Entretien
CAUTION Maintenance and repairs must be
done by qualified personnel.
WARNING
To reduce the risk of electric shock
unplug before cleaning or servicing.
32
The switch housing cover is removed by taking out the three screws
then lifting off. Circuit board (33) can be removed by loosening
screw (32).
26
To remove the dust bag housing (2) from the
vacuum motor housing (1) take off the back
cover and remove the four large screws.
Keeping the power head attached, the dust
bag housing can be eased off.
To remove the vacuum motor, first detach the
two black wires from the terminal block.
When replacing ensure that the motor sup-
port is fully located onto the motor cover.
The motor cover should then be firmly loca-
ted onto the vacuum motor and the motor,
with its cover and support, firmly seated into
position as shown in the vacuum motor
housing.
When properly seated the motor cannot be
turned. Replace motor seal.
To remove the power head cover, take off the
brush strip cover (26) and remove the four
large screws (27) from underneath the
chassis. The cover can then be lifted off.
To Next Page
Loading...
Need help?
General
