7" MAX ROOF THICKNESS
OPTION 3 - GATEWAY ON CEILING
COMPATIBLE WITH ROOF RADIUS OF 230 INCHES TO FLAT
1" HOLE IN ROOF
OTA CABLE
WIFI/4G CABLES
1" HOLE IN CEILING*
GATEWAY
ETHERNET CABLE (OPTIONAL)
PREWIRE HOLE COVER
*MUST BE BELOW OUTDOOR UNIT
RED WIRE - TO SWITCH
BLACK WIRE - TO GROUND
PARK CABLE IN
TV OUT 1
TV OUT 2
TO ANT IN
+12V DC
GROUND
+12V DC
3A FUSE RECOMMENDED
WIFI POWER CABLE
ANT IN
*Must be below outdoor unit
Compatible with roof radius
of 230 inches to flat
Gateway
1" hole in roof
OTA cable
WiFi power cable
Red wire to switch
Black wire to ground
Ethernet cable (optional)
7" max roof thickness
To Ant in
3A fuse
recommended
+12V DC
1" hole in ceiling*
Prewire hole cover
+12V DC
TV out 2
TV out 1
Ant in
Ground
–3–
WiFi/4G cables
Park Cable in
Product Information
The Winegard
®
Air
™
360
+
system will bring in over-the-air local broadcast
television out of the box but has also been designed with the ability to work
with the Winegard Gateway as a WiFi and 4G LTE Extender. It is not intended
to work with any other router system.
The Air 360
+
is designed for RVs with a roof-radius of 230 inches to flat and
with a maximum 7 inch roof thickness.
The Air 360
+
allows the Winegard Gateway
™
to be installed in two locations;
inside the dome of the antenna or on the ceiling of the RV. For better
performance, it is recommended to install on the ceiling of the RV shown in
Option A below, however either option is acceptable.
The Air 360
+
can replace another TV antenna and can utilize the coax cable
that has already been installed. If doing this, you must ensure the coax
runs to the Winegard antenna wall plate/power supply and, if the Winegard
Gateway is to be installed, that the power cable is routed to the Gateway wall
plate/power supply.
It is recommended to install the Air 360
+
before attempting to install the
Gateway
™
system. Winegard recommends installing the Gateway directly
under the Air 360
+
. Once the Air 360
+
has been installed, there are two
requirements to finding a location on the RV ceiling for installation: +12VDC
must be present, and the three WiFi/4G antenna cables from the Air 360
+
must be able to reach the connection points on the Gateway router.
A. Ceiling Mount Install (Recommended)