Wing Bikes Freedom - Charger Operation and Safety; Charging Procedure; Battery Removal and Installation

6
 The charger will automatically stop when the battery pack is full so you can charge overnight.
 Always charge in dry locations and indoors away from direct sunlight, dirt or debris.
 Do not cover up the charger when plugged in or charging, it air cools and needs to be left in a
clear space. Do not charge with the charger in the inverted position which can inhibit cooling
and reduce the chargers life.
 Check the charger cables, charger and battery for damage before beginning each charge.
 The light on the charger will turn green when charge is complete and stay red while the battery
charges.
 Charging normally takes 3-5 hours, however it can take longer when you first receive the bike
since the battery pack is balancing.
 Charge in a clear area away from potential to trip on the charging cords, or damage to occur to
the bike, battery or charging equipment while parked.
Charging Procedure
Follow these steps for charging your Wing Bike:
1. Remove the rubber cover on the charging socket.
2. With the battery on or off the bike, place the charger in a flat, secure place, and connect the DC
output plug from the charger (round barrel connector) to the charging port on the end of the
battery pack.
3. Then connect the input plug to the power outlet, charging should initiate and will be indicated
by the LED charge status light on the charger turning red.
4. After charging, unplug the charger from the wall outlet first and proceed to remove the charger
DC plug from the bike battery socket.
Always charge your battery in temperatures between 50 and 80 degree Fahrenheit and ensure the
battery and charger are not damaged before initiating charge. If you notice anything unusual while
charging please discontinue charging and use of the bike and contact Wing Bikes for help.
When the Battery Is Removed
 Do not touch the “+” and “-“terminal contacts on the top of the battery when the battery is
removed from the bike.
 Be careful not to drop or damage the battery pack when
loose from the bike.
 Ensure the bike is turned off whenever you are removing
the battery from the bike.
When Installing the Battery onto the Bike
 Do not force the battery onto the receptacle, slowly align and push battery into
the receptacle.
 Ensure the battery is in the locked position before riding,
there should be an audible click when installed properly.
To best check that the battery has been properly