8
Operation
Start-Up Procedure
After the bike has been properly assembled following the unboxing instructions and all components are
secured correctly, you may now proceed to start up the vehicle and select the drive mode and power
level via the display on the handlebars.
Notice:
Do not perform any of the steps in the Operation section of this manual until you have read
this entire manual since there are important details in the following sections, especially related to
safety.
1. Secure the battery pack to the frame mount. Remove the key and test to see the battery cannot
be removed before proceeding.
2. Hold down the center power button on the handlebar display for 2 seconds then release, the
LCD readout should turn on.
3. Select your desired level of pedal assistance between level 1 and 5 using the up and down
arrows on the handlebar display. Level 1 corresponds to the lowest level of pedal assist, and
level 5 corresponds to the highest level of pedal assist. The approximate top speed of each level
of pedal assist is show in the table below:
Approximate Assisted Speed
4. If you purchased the optional throttle, the throttle power overrides each pedal assist mode, and
has the same power output as pedal assist level 5.
5. To turn on the lighting system once the battery/LCD display are on, hold down the up arrow on
the handlebar display for 2-3 seconds.
Users must become accustomed to the bikes power control system before operating. The throttle
mechanism allows full power to be activated from a stop and inexperienced users should take
extra care when first applying the throttle. The pedal assistance feature is also a powerful option
and users should fully research and understand how to operate it before first use. Not taking care
to familiarize yourself and practice the operation of the power system on your Wing Bike can lead
to death or serious injury, please head this warning.
6. With the proper safety gear and rider knowledge and understanding you may now proceed to
operate your Wing Bike. You can begin by pedaling the bike in the appropriate drivetrain gear
with or without pedal assistance. You may also use the throttle to accelerate and maintain your
desired speed.
To Next Page
Loading...