9
Users must follow the instructions and warning contained in this manual for their safety. Do not
attempt to operate your Wing Bike until you have attained adequate knowledge of its control and
operation. Damage caused by failing to follow instructions is not covered under warranty and
could result in personal injury to you or others as well as damage to property and/or your Wing
Bike. Contact Wing Bikes if you have any questions about assembly or operation.
LCD Display Features
The image shows the various features and information displayed on the wireless remote. The display is
controlled using the 3 buttons located left of the screen. For more information on the LCD display and
operation please refer to the SW-LCD manual in the Appendix.
Driving Range
The range of your Wing Bike is the distance the bike will travel on a single full charge of the onboard
battery pack. Some of the factors which effect range include changes in elevation, speed, payload,
and acceleration, number of starts and stops and ambient air temperatures. Tire pressure and terrain
are also important variables to consider.
We suggest that you ride conservatively when you first get your Wing Bike to get to know your bike and
travel routes. Once you become familiar with the range requirements of your travel routes, and the
capabilities of your Wing Bike you can then adjust you riding characteristics if you so desire. Wing Bikes
makes no claims to the range that individual users might obtain.
Battery Capacity Display
The LCD readout on the handlebar of your Wing Bike features a battery capacity gauge (much like the
fuel gauge on an automobile). It is recommended that users stop operating the bike once one bar is left
on the display. Once the battery is fully depleted, the last remaining bar will begin to flash,
communicating to the user that they should cease operation immediately.
Best Practices for Extending Range and Battery Life
Notice:
It is recommended that users pay close attention and ride within the following limitations to
ensure the hub motor does not overheat or become damaged from excessive loading.
o Do not climb hills steeper than 15% in grade.
o Pedal to assist the motor when climbing hills and accelerating from a stop.
o Avoid sudden starts and stops.
o When climbing hills reduce the power output to 200 watts or less. This can be accomplished by
pedaling with the bike while in pedal assist modes 1 or 2.
o Accelerate slowly.
To Next Page
Loading...