Wing Bikes Freedom - Recommended Torque Values; Adjusting Seat Height; Rider Comfort; Battery Charging Tips

5
Do not extend any components including the stem, rear rack, or seat post beyond the insertion
marking etched into the components. Ensure that all hardware is properly tightened and secured
before moving on to next step otherwise serious injury or death could occur.
Recommended Torque Values
Hardware Location
Torque Required (Nm)
Handlebar
18-20
Stem
18-20
Saddle
18-20
Seat
18-20
Front Wheel (For Bikes With Bolt On Front Wheel)
16-25
Rear Wheel
30-35
Bottom Bracket Parts
35-55
Pedals
35
Disk mounting Bolts
6
Disk Caliber Mount
10
Crank Bolts
40
Rear Derailleur Cable Pinch
6
Front Derailleur Clamp
7
Seat Post Clamp
7
Adjusting Seat Height
Use the included hex wrench to loosen the clamp and free the seat post and pull upwards or push
downwards to reach desired height.
Notice:
Ensure seat post and seat are properly adjusted before riding. Do not raise the seat post beyond
the insertion marking etched into the seat post tube. If your seat post projects from the frame beyond
these markings, the seat post or frame may break, which could cause you to lose control and fall. Prior
to first use, be sure to tighten the seat clamp properly. A lose seat clamp or seat post binding bolt can
cause damage to the bicycle or can cause you to lose control or fall. Periodically check to make sure
these the seat clamp is properly tightened.
Rider Comfort
To obtain maximum comfort, the rider should not overextend his or her arms reach when riding. In
order to obtain the most comfortable riding position and offer the best possible pedaling efficiency, the
seat height should be set correctly in relation to the rider’s leg length. The correct saddle height should
not allow leg strain from over extension, and the hips should not rock from side to side when pedaling.
While sitting on the bicycle with one pedal at its lowest point, place the ball of your foot on that pedal.
The correct saddle height will allow the knee to be slightly bent in this position.
Battery Charging Tips
 The battery should be recharged after each use. There is no memory effect so you can charge
the battery after short rides without damage.
 The battery can be recharged on or off the bike.
 Remove the battery by turning the key and then pulling the battery towards the direction of the
battery handle until the battery lifts off of the mounting receptacle.